EC Certif icate Type Examination (Module B) This is to certify (hat: Germanischer Lloyd, a Notified Body under the terms of the Marine Equipment Directive 96/98/EC of 20 December 1996, notified by the German Federal Ministry of Transport, Building and Urban Development, did undertake the relevant type approval procedures for the equipment identified below which was found to be in compliance with the requirements of Marine Equipment Directive (MED) 96/98/EC äs amended, subject to any conditions in the schedule attached hereto. Certificate No. Applicant 20 414-11 HH Egon Harig GmbH Gewerbering 4 22113 Oststeinbek, GERMANY Product Description Optical UV-Flame Detector Product Name Trade Name Specified Standards EN 54-10 (2002) including A1(2005) IEC 60092-504 (2001) IEC 60533 (1999) Related Directive Equipment Section Annex A.1 Item No. 2012/32/EU Fire protection A.1/3.51 Date of Re-issue Expiry Date 2014-07-17 2019-07-16 Germanischer Lloyd Nils Wegener Notified Body No.: 0098 Page 1 of 2
Certificate No: 20 414-11 HH Date of Re-issue: 2014-07-17 Schedule of Approval Approval Documentation Test reports: BMA 08104, U 251-03 (30.09.03), 05-10/2003 (18.11.03); Data Sheet: 4.3125.1-1, Operating Instructions: 4.3125.2-1, Description: 4.9071.1-1 Drawings and circuit diagrams according to submitted files Technical Data Alarm sensibility: according to EN54 part 10, class 1 Power supply: 24V DC Current Consumption in Operation: approximately 33mA (at 24V DC) Current Consumption at Alarm Indication: approximately 52mA (at 24V DC) Outputs: 1 potential-free close contact for voltage and failure monitoring (closed in Operation) 1 potential-free close contact for fire alarm monitoring Output contacts rating: 30V DC, 1 A Supervision angle adjustable: 90 with diaphragm 30mm, 45 with diaphragm 50mm 30 with diaphragm 69mm Housing material: PC-LEXAN 241R Remarks IEC 60092-504 (2001) and IEC 60533 (1999) with test for equipment installed in the bridge and deck zone. Limitations on the acceptance or use of the product None Notes: This certificate is valid for equipment, which is conform to the approved type. The manufacturer shall inform Germanischer Lloyd, äs the Notified Body, of any modifications or changes to the approved equipment. Should the specified regulations or Standards be amended during the validity of this certifiate, the product is to be re-approved before being placed on board a vessel to which the amended regulations or Standards apply. The mark of conformity may only be affixed to the above type approved equipment and a Manufacturer's Declaration of Conformity issued when the production-surveillance module (D, E or F) of Annex B of the MED is fully complied with and controlled by a written inspection agreement with a Notified Body. Page 2of2
EC Certificate of Conformity Quality System (Module D) Germanischer Lloyd äs the notified body, notified by the German Federal Ministry of Transport, Building and Urban Development, performing the quality assessment procedures certifies that the manufacturer maintains and applies a quality System which is in compliance with the requirements of the Marine Equipment Directive (MED) 96/98/EC, äs amended, ensuring that the equipment identified below is conform to the type äs described in the EC Type Examination Certificate, subject to any conditions in the annex attached hereto. Certificate No. Manufacturer 20 415-11 HH Egon Harig GmbH Gewerbering 4 22113 Oststeinbek, GERM ANY Scope: A.1/3.51 Fixed fire detection and fire alarm Systems components for control stations, Service spaces, accomodation spaces, cabin balconies, machinery spaces and unattended machinery spaces Related Directive Date of Re-issue Expiry Date 2012/32/EU 2014-07-17 2019-07-16 Germanischer Lloyd Nils Wegener Notified Body No.: 0098 Page 1 of 3
Certificate No: 20 415-11 HH Date of Re-issue: 2014-07-17 Remarks None Notes: This certificate authorises the manufacturer in conjunction with the EC Type Examination (Module B) Certificate of the equipment listed before to affix the Mark of Conformity (wheelmark) to the product described herein. This certificate loses its validity if the manufacturer makes any changes or modifications to the approved quality System, which have not been notified to, and agreed with the notified body named on this certificate and/or after lapse of time, withdrawal or revocation of the EC Type Examination (Module B) Certificate. Wheelmark Format and application: 0098/yy 0098 yy Notified Body number undertaking quality surveillance Last two digits of year in which the mark is affixed Page 2of3
Annex to CertificateNo:20415-11HH Date of Re-issue: 2014-07-17 Item A.1/3.51 Item Description Product Name Trade Name Module B No. Date ctf Date of Notified USCG Approval No. lssue expiry Body Comment to USCG Approval (if applicable) Fixed fire detection and fire alarm Systems components for control stations, Service spaces, accomodation spaces, cabin balconies, machinery spaces and unattended machinery spaces 20 414-11 HH 17.07.2014 16.07.2019 0098 Page 3of3
EG Konformitäts - Erklärung EGONHARIG flamtron Electronic Systems Fire alarm Systems Wir erklären hiermit, dass die folgenden angegebenen Geräte der Marine Richtlinie 96/98/EG, zuletzt geändert durch die Richtlinie 2010/68/EG, entsprechen. Bezeichnung: Typ: Hersteller: Adresse: UV-Flame Detector 800/24 VST-K- Gewerbering 4, D-22113 Oststeinbek....Deutschland... Dieses Gerät wurde auf die Einhaltung der folgenden Verordnungen und Prüfungen getestet:..2012/32/eu, A.1/3.51 Stand: * Baumusterprüfung (Modul B) Zertifikat Nr 20 414-11 HH.. * Einzelprüfung (Modul D) Zertifikat Nr 20 415-11 HH. Herausgeber:...DNV GL SE Zur Identifizierung wird folgende Markierung am Produkt angebracht:: 0098" und das Janr der Herstellung (12,13,14...) Eine technische Beschreibung des Produktes findet man unter folgender Adresse:.. http://www.egonharig.de/vst K N.html... Ort / Datum Zg.-Nr. Version Oststeinbek, 17.07.2014 4.09198 2 Gewerbering 4 ' D-22113 Oststeinbek Tel./Phone: +49 (0)40 713752-0 Telefax: +49 (0)40 713752-24 E-Mail: egonharig@egonharig.de www.egonharig.de www.flamtron.de Prüfer: G. Martens (QS-Beauftragter) (21.07.2014) Q6 / EGON HARIG O:\_Technische Beschreibungen\Flammenmelder\800_24 VST- K\Deutsch\4.09198 EG Konformitatserklarung.doc Seite/Page 1 von/of 1
EC DECLARATION OF CONFORMITY EGONHARIG flamtron Electronic Systems Fire alarm Systems We hereby declare that the following specified equipment complies with the Marine Equipment Directive 96/98/EC, äs amended, last amended by Directive 2010/68/EC Equipment description: Type: Manufactured by: Address: UV-Flame Detector 800/24 VST-K- Gewerbering 4, D-22113 Oststeinbek. Germany This equipment has been tested to verify compliance with the following Regulations and Testing Standards:..2012/32/EU, A.1/3.51.. As per: *Type-Examination (Module B) Certificate No....20 414-11 HH. *Unit Verification (Module D) Certificate No Issuedby...DNVGLSE... 20 415-11 HH. Product affixed with following mark(s) and identification: the year of manufacturing (12,13,14...) A Technical Constriction File for this equipment is retained at the following address:.. http://www.egonharig.de/vst K N eng.html... Inspector : G. Martens (QS-Beauftragter) (21.07.2014) QS / EQQN HARIQ Place / Date Drg.-N Update Oststeinbek, 17.07.2014 4.09198-1 2 Gewerbering 4 ' D-22113 Oststeinbek Tel./Phone: +49 (0)40 713752-0 Telefax: +49 (0)40 713752-24 E-Mail: egonharig@egonharig.de www.egonharig.de www.flamtron.de O:\_Technische Beschreibungen\Flammenmelder\800_24 VST- K\Englisch\4.09198-1 EC Conformity.doc Seite/Page 1 von/of 1