Inquiry/-Purchase order form for commercial vehicle

Transkript

1 Inquiry/-Purchase order form for coercial vehicle We kindly ask you to fill in the data as complete as possible. This will enable us to select carefully the required product and to deliver at short notice. Inquiry Purchase Stamp/ompany: Vehicle manufacturer: Name of purchaser: Vehicle type: hassis number: Quantity: OE- part number (if available): Delivery date (arriving at customer): OE-part number (if available): Day Explanation: 1 = motor / 2 = gearbox / 3 = transfer gearbox 4 = rear axle / 5 = 2nd rear axle 6 = front axle / 7 = 2nd front axle DGW= Double cardan shaft A F G F G Time F G H I A D A D E F Seite 1 von 9

2 ardan shaft oder EL (working length): PS1 (length of the covertube): A (flange outer diameter) / : R (high of the flange) / : X (cupdiameter) / : E (bore) / : No. of bores / : DIN-connection ross-serrated-connection SAE-connection Seite 2 von 9

3 ardan shafts suitable for Scania X X oder EL (working length): X (cupdiameter): ross-serrated connection ross-serrated connection : E (bore) / : No. of bores / : Seite 3 von 9

4 Intermediate shaft L1 (length): A (flange outer diameter) / : R (high of the flange) : P (lenght of the intermediate shaft) : X (cupdiameter) : E (bore) / : No. of bores / : Type of center bearing Lo (hole distance) : DIN-connection ross-serrated-connection SAE-connection Seite 4 von 9

5 Intermediate shaft suitable for Scania X L1 (length): X (cupdiameter) : ross-serrated-connection ross-serrated-connection E (bore) : No. of bores : Seite 5 von 9

6 for short couple shaft oder EL (working length): PS1 (length of the covertube): A (flange outer diameter) / : R (high of flange) / : X (cupdiameter) / : E (bore) / : No. of bores / : DIN-connection ross-serration-connection SAE-connection Seite 6 von 9

7 Technical questionnare for a set of cardan shafts oder EL (working length) LS1 (length): I2 l3 A (flange outer diameter) / : X (cupdiameter) / : E (bore) / : No. of bore / : DIN-connection ross-serrated connection SAE-connection NV3-connection Hole distance (Lo) : Seite 7 von 9

8 for cardan shafts suitable for Mechanics E oder EL (working length): PS1 (length of the covertube): D (hole distance) / E (hole distance) / : Locking code HWD-High Wing Drilled LWT-Low Wing Threaded LWD-Low Wing Drilled DWT-Delta Wing Threaded Seite 8 von 9

9 / Double cardan shaft L1: L12: L13: X: Types of thrust washers Without thrust washer 2 x thrust washer 1 x thrust washer 1 x thrust washer 1 x cartridge seal H1 = H2 = Fixing of different types of axle pivots With crescent rings With 1x threaded bores With 2x threaded bores With clips With threaded pin With bearing pin Types of axle shafts Simple serration Double serration Triple serration Seite 9 von 9