Command 2.5 Geheimmenue: "MUTE"+"1"+"3" gleichzeitig ein paar Sekunden dräcken wenn man im Radio Menu im Command ist...

Transkript

1 Command 2.5 Geheimmenue: "MUTE"+"1"+"3" gleichzeitig ein paar Sekunden dräcken wenn man im Radio Menu im Command ist... Verstecktes ServicemenÄ im Kombiinstrument Diese Funktion låsst sich normalerweise in allen Modellen der Baureihen 203, 208 (MOPF = modellgepflegt), 209, 210 (MOPF = modellgepflegt), 211 und 220 (vor MoPf) abrufen. Untenstehend wird der Vorgang beispielhaft dargestellt. (1) FBS (elektronischer SchlÄssel = Fahrberechtigungssystem) einstecken und nach rechts in Stellung 1 drehen. Im MFD (Multifunktionsdisplay) erscheint das GrundmenÄ (Tages-WegstreckenzÅhler und Gesamt-WegstreckenzÅhler). (2) Sollte das GrundmenÄ nicht direkt erscheinen, den linken unteren Lenkradknopf mit den zwei BlÅttern (siehe Bild 2) so oft dräcken, bis das GrundmenÄ angezeigt wird. (3) Nun den RÄckstellknopf (links am Kombiinstrument) fär ca. 30 Sekunden in gedräcktem Zustand halten, bis ein Piepton ertçnt. (4) Durch einmaliges DrÄcken des linken unteren Lenkradknopfes mit den zwei BlÅttern das ServicemenÄ aufrufen. (5) Es erscheint nun das ServicemenÄ mit Angabe der Software- und Hardwareversion. Bei manchen KI ist die Zeile "ÉLSTAND: -.- l" zu sehen. Dann kann das FBS in Stellung 2 weitergedreht werden, und nach einigen Sekunden kann der Élstand (und darunter die Motorkennung) abgelesen werden. z.b. Kombi-SW: 39/01 Kombi-HW: 42/00 Motor: M113, E50 SW:_DCW220MJ "REST"+"Umluft" "REST"+"AktivKohleFilter" Liste Fehler Radiomenue "MUTE"+"1"+"3" Liste der Codes Klimadisplay Aufruf am Klimadisplay mit REST + HECKSCHEIBENHEIZUNG Test/Steuerung fär MotorlÄfter und GeblÅse 0 AAC in-car temperature sensor (operating module) 1 Overhead control panel for in-car temperature sensor 2 Outside temperature sensor 3 Left heater-exchanger in car temperature sensor 4 Right heater-exchanger in-car temperature sensor 5 Evaporator core sensor 6 Engine temperature 7 Refrigerant pressure 8 R134A refrigerant in-car temperature sensor

2 10 Blower control voltage 15 Average insolation value between 0 and 125% 16 Carbon monoxide value between 0 and Nitrogen oxide value between 0 and Dew point temperature 20 Fan output value between 0 and 100% 21 Engine speed 22 Ground speed 24 Battery voltage 27 Left hand potentiometer engine speed value between 0 and 100% 28 Centre potentiometer engine speed value between 0 and 100% 29 Right hand potentiometer engine speed value between 0 and 100% 30 Temp of blow air in left rear passenger-compartment 31 Temp of blow air in left rear passenger-compartment 32 Temp of evaporator core in rear passenger compartment 33 Blower voltage in rear passenger-compartment 34 Specified temperature in left rear passenger-compartment 35 Specified temperature in right rear passenger-compartment 40 Left hand defroster door value (open/closed plain text at limit stop) 41 Right hand defroster door value (open/closed plain text at limit stop) 42 Left hand footwell flap value between 0 and 100% 43 Right hand footwell flap value between 0 and 100% 44 Left hand blend flap value between 0 and 100% 45 Right hand blend flap value between 0 and 100% 46 Left hand diverter flap 0 and 100% 47 Right hand diverter flap value 0 and 100% 48 Recirculation door 0 and 100% 49 AKF bypass flap 0 and 100% 50 AAC Software 51 AAC Hardware

3 52 Software for rear passenger compartment air conditioning 53 Hardware for rear passenger compartment air conditioning 54 Software for stepper motor unit 55. Hardware for stepper motor unit 56 Software for centre nozzle 57 Hardware for center nozzle 58 Software for multifunction sensor 59 Hardware for multifunction sensor 60 Sofware for day-brightness sensor 61 Hardware for day-brightness sensor REST + OFF Taste ( die O Rechts unten ) 99 EintrÅge mit ErklÅrung Set A/C control unit in diag mode: Ñ Push both charcoal filter button and REST at the same time. You can scroll how many faults the a/c system has by using the temperature selector button. B1000 Control unit N22 (AAC pushbutton module) is defective. B1022 Fault in CAN communication w/ control unit ESA-FL (Electrically adjusted front left seat) B1023 Fault in CAN communication w/ control unit ESA-FR (Electrically adjusted front right seat) B1053 Fault in CAN...DCM-RR (Door control module rear right) B1054 Fault in CAN...DCM-FR (Door control module front right) B1055 Fault in CAN...DCM-FL (Door control module front left) B1056 Fault in CAN...DCM-RL (Door control unit rear left) B1057 Fault in CAN...OCP (Overhead Control Module) B1059 Fault in CAN...SAM-FL (Front Left Signal Aquisition Module) B1074 Fault in CAN...EIS (Electronic Ignition Switch) B1075 Fault in CAN...SAM-FR(front right Signal Aquisition Module) B1076 Fault in CAN...REAR SAM (Rear Signal Aquisition Module) B1087 Fault in CAN...TSTH (Stationary Heater)

4 B1088 Fault in CAN...ICM (Instrument Cluster Module) B1219 N22b1 (In car temperature sensor) B1228 B10/2 (Left heat exchanger temperature sensor) B1229 B10/3 (Right heat exchanger temperature sensor) B1230 B10/6 (Evaporator sensor) B1241 Refrigerant Level is too low B1256 B10/6 (Evaporator temperature sensor) Evaporator front B1257 Refrigerant pressure is 0 bar B1267 Communication Fault of A/C bus B1268 Communication fault of A/C bus w/ control unit N18/4 (Center vents electronic control module) B1269 Communication fault of A/C bus with control unit B31/1 (AAC multi function sensor) B1270 Communication fault of A/C bus w/ control unit B32/2 (AAC sun sensor (4 in total)) B1271 Communication fault of A/C bus w/ control unit N22/5 (Stepping motor electronics control module) B1298 B10/6 Evaporator temperature sensor (Evaporator rear) B1417 A31y1 (left duo valve) Heater valve B1418 A31y2 (right duo valve) Heater valve B1424 A32m2 (activated charcoal filter flap adjustment motor) B1434 Voltage supply of A/C bus B1451 M16/17 Left center vent diverter flap actuator motor B1452 M16/19 Left center vent temperature regulating flap actuator motor B1453 M16/21 Fresh air and recirculated air flap actuator motor B1455 M16/13 Left defroster nozzle flap actuator motor B1456 M16/14 Right defroster nozzle flap actuator motor B1457 M16/15 Left footwell flap actuator motor B1458 M16/16 Right footwell flap actuator motor B1463 M16/18 Right center vent diverter flap actuator motor

5 B1464 M16/20 Right center vent temperature regulating flap actuator motor. B1849 Fault in CAN communication with control unit N22/4 rear A/C control unit Ñ To delete the fault press left AIR AUTO button and then press right AIR AUTO button. Ñ Press out the right AIR AUTO button and then press out the left AIR AUTO button, after you did this the display will show it is deleting fault codes.